Single cylinder dryer
Production capacity: customizable
Area: about 5x15-7x25㎡
Application scope: drying of pomace, medicine residue, sauce lees, sugar residue, starch residue, poultry manure, slaughter scraps, mining, fertilizer and other materials
Heat source configuration: suitable for multiple fuels
Environmental protection configuration: supporting use of multi-stage dust removal equipment
Product Introduction
Single cylinder dryers are widely used in food, feed, chemical, pharmaceutical, mining, fertilizer and other industries. According to the requirements of drying products, different heat sources can be used. This machine is suitable for drying all kinds of slag materials with water content less than 85%, such as beer lees, alcohol lees, pomace, medicine dregs, sauce lees, sugar dregs, starch Residues, livestock manure, scraps from slaughter, etc. It has a good effect on opening up feed resources, reducing feeding costs and reducing environmental pollution. The single-cylinder dryer is also known as the tumble dryer. The cylinder is a horizontal rotating cylinder. The inside of the drum is welded with a variety of staggered plates from front to back. It has a reasonable structure, excellent production, high output, and It has the advantages of low consumption and convenient operation. It is a kind of dryer equipment widely used in mining equipment. Drying materials further turn waste into treasure, we have mature technical experience

working principle
The single-drum dryer is mainly composed of a heating source, a feeder, a feeder, a rotary drum, a discharging machine, an induced draft fan, a discharger and a power distribution cabinet; after the dehydrated wet material is added to the dryer, the drum When the evenly distributed plate copying device is turned, it is evenly dispersed in the dryer and fully contacted with hot air, which accelerates the speed of heat and mass transfer during drying. The material is dried under the action of the inclined board and heat medium. In the other section, the star discharge valve discharges the dried finished product.
In the process of material drying: the wet material is sent to the hopper by belt conveyor or bucket elevator, and then enters the feeding end through the feeding pipe through the feeding machine of the hopper. The inclination of the feeding pipe should be greater than the natural inclination of the material so that the material can flow smoothly into the dryer. The dryer cylinder is a rotating cylinder slightly inclined to the horizontal. The material is added from the higher end, the heating medium enters from the lower end, and it comes into countercurrent contact with the material. There is also the heating medium and the material flow into the cylinder together. There is a copy board on the inner wall of the cylinder. Its function is to transfer the material. Rise and scatter to increase the contact surface of the material with the airflow to increase the drying rate and promote the advancement of the material