15 tons-20 tons corn processing equipment
The 20-ton corn processing equipment can process 20-25 tons of raw corn grains per day. Using dry corn processing technology, the depuration rate of the skin embryo reaches 95%. The corn processing equipment can produce refined corn flour (the taste is fine and pure, and the fineness can reach 120 meshes), and various corn grains (corn grits). Products such as corn germ and corn husk.
The corn goes through the cleaning sieve to remove impurities and enters the moisturizing hoist. In the moisturizing hoist, the corn processing skin is soaked in water and then enters the storage box, and then enters the peeling crusher. After the corn is peeled and crushed, it enters the embryo extracting machine The germ and the skin are separated, and the corn grits after the peeling and germ removal enters the pulverizer to grind and flow out from the discharge port of the receiver. Corn-Screening-Moisturizing-Peeling-Stripping-Screening-Germ Extraction-Corn Grits-Milling-Bagging.

The 15-ton corn processing machine adopts the dry-method corn dehulling and degerming technology, and the de-cleaning rate of hull germ reaches 90%. Corn processing equipment can produce refined corn flour (with a fine and clean taste and a fineness of 60 to 80 mesh) and other products. Additional equipment can be further processed into corn porridge flakes, fast food corn flour, corn oil, corn noodles and other products. The equipment has low energy consumption, installed power of 30kW, automation degree, reliable and convenient operation. The output is 400~500kg/h. The yield can reach 80%~85%. 2-3 operators.

Corn processing is based on the premise of peeling. Corn peeling generally adopts wet peeling. The moisture content of the corn in the machine is required to reach 16-17%, and the moisture time is about 10 minutes. Only the lower skin is moistened and it is strictly prohibited to enter the machine. There is water on the corn surface, otherwise stuffiness should occur. After the machine is turned on and running normally, open the feed plate and control the material flow at the feed port according to the power load. During operation, if any abnormal sound is found, stop the machine for inspection immediately. When the car is stuffy, you should close the feed plate, turn the motor wheel slowly by hand, remove the corn in the cabin, and start the machine again.