Agitator-Pulp Processing Machine
Product introduction:

FJB agitator is a suspended slurry tank agitator, which is suitable for mixing slurry of different concentrations in a slurry tower, round slurry tank and square slurry tank. It is hung on the pool wall with flanges and does not need to be fixed with a cement foundation. It has a small footprint, easy installation and low power.
Structure principle
It is mainly composed of six parts: impeller, transmission unit, packing seal unit, belt drive unit, frame unit, mounting ring and protective cover.

1. Impeller

It is composed of an impeller seat, a blade and a ball cap. The blade and the impeller seat are connected by positioning pins and bolts. The angle of the blade can be adjusted by adjusting the combination of positioning pin holes.

2. Transmission unit

It is composed of bearing seat, bearing, main shaft, shaft sleeve, slinger ring and spacer sleeve. The bearing seat and bearing support the main shaft. The shaft sleeve is equipped with the corresponding filler of the main shaft to protect the main shaft. The spacer sleeve is installed at the part where the main shaft extends into the slurry tank to prevent the main shaft from corroding.

3. Packing and sealing unit

It is composed of packing chamber, packing, water divider ring, gasket and gland. The gasket can only be removed when replacing the packing with slurry, and the packing can be replaced by tightening the packing chamber.

4. Belt drive unit

It is composed of motor, motor pulley, host pulley, V belt, motor bottom plate and screw. The motor transmits power to the main shaft through a belt.

5. Rack unit

It is formed by welding square tube and steel plate. It is used to fix the bearing seat and the screw of the belt drive unit, and the front flange is connected with the mounting ring.

6. Mounting ring

The installation ring is divided into steel slurry tank installation ring and cement slurry tank installation ring. If the slurry tank is made of steel, use the former, if the slurry tank is cement, use the latter.

7. Protective cover

It is welded by sieve plate and bending plate, used to protect the belt pulley and main shaft.